Request for a 190 trailer pic

[jk1]

Looking for a picture specifically of a front V bunk on a 190 trailer. Can't get one from EZ loader. NCangler has a good schematic that is helpful, but would like a pic just so I can see all the brackets in relation to the frame and bunk boards and what not. My old trailer was never equipped with front V support or ft cross member, so I plan to fabricate something. Thanks, JK

 

[Dave LeGear]

When I owned my 190 I did not have a factory trailer either, but added a simple v block to mine back when I had her and maybe these shots will help? Here is that part: https://www.easternmarine.com/magic-tilt-bow-rest-guide-assembly-pv2280-3

You can also see how I had boards and carpet added to the inside of the fenders, to help keep any hull scrapes from happening, and helping her load faster If needed you can also find those boards here: https://www.easternmarine.com/magic-tilt-aluminum-fender-pad-pi1970b






Hope this helps?

Dave

 

[jk1]

Sweet, Pretty simple setup. Heading to trailer superstore site now. Thanks Dave

 

[Dave LeGear]

Most welcome!
And adding that forward cross member under that support should be easy enough (simple bolt on) and many places should have such. Now who is the builder of your trailer? Very possible on their website you can find such and then, use the link above to order the V Block

 

[jk1]

EZ loader adjustable. I have been on their site, but not really sure of what #3 crossmember I need. The frame narrows up front of course where the V support will be , I've really only seen full frame width crossmembers on EZ loader parts catalog. I'll probably do all shopping at trailer super store. Just get universal member ant cut to length if needed. Dave, you have already made life much easier with the link for the V support. Thanks

 

[LoonLovers]

Here is a photo of the factory trailer setup for our 191 FS. It seems to load easy.

 

[jk1]

Thanks for the picture. Very helpful